Best clips for planer boards

[wakina]

Looking at the boards now. Should I tighten the screw on the front clip all the way down? So that it just barely allows the braid to fit in there? Maybe we didnt tighten enough. The line was only 8lb diameter and very slick superline.

I am shooting you straight here and I am sorry to inform you but it makes no difference how new or old your release is. If the line slips thru the release/clip it (the line) cuts the rubber gripping material rendering that clip/release useless. Been there done that a few times in the past and it only took once on most occasions. That super line/braid is mean stuff.


Start by tightening the clip a 1/4 turn at a time and try to remove the line by hand in the same fashion that it is now releasing, be sure to put the line as close to the spring as possible before testing. Also try to make the line slip from front to back along the length of the board. if you have movement in either test tighten the clip another 1/4 turn and re test, keep doing this until you get no movement or you can tighten the clip/release no further. Both of these test are done within reason as you may be able to apply more pressure by hand than what would be applied by the board while actually fishing, your judgement will help you out at that point.

Please be aware the line may have already ruined the rubber coating on the clip, it only has to slip a few times or a few feet to cut that rubber coating on the clip/release.