Church TX44 board problems

[BZZ]

The lock jaw clips work great.

Another option that is really easy is to turn the pinch clip around the opposite way-the open end should be where the thumb tension clip normally is. Physics keeps the line from sliding out.

[Eyezcrazy]

The lock jaw clips work great.

Another option that is really easy is to turn the pinch clip around the opposite way-the open end should be where the thumb tension clip normally is. Physics keeps the line from sliding out.

It took me a minute to figure out how that would work but I finally got the visual. So by turning the clip around backwards you are saying the force of the line pulling will actually pull the line deeper into the bite of the clip. Sounds good to me! I will give this a try. Thanks for the tip!

[Muskieslayer]

The lock jaw clips work great.

Another option that is really easy is to turn the pinch clip around the opposite way-the open end should be where the thumb tension clip normally is. Physics keeps the line from sliding out.

On the TX44 boards, the clip is already reversed (open end where the line is attached facing towards the board) and they still slip. I will give the rubber band idea a try or give the line an extra loop around the clip.