Off Shore Board Parts

[Lowe Budget]

Does anyone know where I can fine just the wire that runs from the flag to the clip on the back of the board for the tattle flag kits. I just need 3 wires, I have everything else I need but don't want to pay $20+ dollars a piece for the tattle flag kits when all I need is the wire.

[ebijack]

1/16 S.S. welding rod, you will need 2 pieces as one rod will make 2 of those wires with a small piece lef t over.

[Fish Tales]

Jann's Netcraft carries .040 stainless wire in small rolls. I used it this spring to do the same thing your doing on eight boards.

[wakina]

Does anyone know where I can fine just the wire that runs from the flag to the clip on the back of the board for the tattle flag kits. I just need 3 wires, I have everything else I need but don't want to pay $20+ dollars a piece for the tattle flag kits when all I need is the wire.

Where are you located? Home or boat! I have some heavy wire that was intended for spinner baits. If you would want it and we are close enough you can have the 3 PCs you need. I used it to fabricate tattle tail flags for a set of TX-44 boards it works really well and is more than long and heavy enough. I bought several pieces for a little of nothing on Ebay a few years ago. It is 13" long and .035 thick and has never been used.

I edited to add a picture of the wires.

[Throttles Down]

Made mine from plain spreaders, using needle-nose pliers

[wakina]

If any one would want some let me know. Could meet at the Bessie area for pickup. PM me if interested.

[Capt Juls]

www.offshoretackle.com