Dialed in.

[Frank]

Let it swing further back behind the boat before reeling in.

[branhamautomotive]

Let it swing further back behind the boat before reeling in.

How do you get it to swing back, if the fish that is on, us big enough it pulls back and they come up with the tripped jet, put some of the 7 inch fish don't pull the board back or trip the jet.

I could see if you knew there was nothing on just opening the reel to free spool let it drop back. But if you thought there might be you would not want to just let it slide back with that slack, bye bye fish.

Tried putting my snappers on the back and my red clips up front but the braid slides right through, tried using rubber band up front in the red clips, they just stretch, alot, thought since I was pulling 40 tt it might be like big boards there, nope. I was hopig to be able to pop the front clip like you would with big boards, use the snapper in the rear to keep the board from falling off or sliding down the line, and let it just fall back out of line and come straight in the back, not in on the corner.

I seem to have alot more trouble with tangles this way when u runn 3 boards on a side, not too bad with just two. I was thinking about moving my rod holet's farther forward to give we that few extra feet of drifting back before having to cross over.

[Bggeary]

Try using two stern planers and two boards out the side. Piece of cake.

[Frank]

You had to disengage your real and thumb the real until it falls back behind your spread. Keeping some tension on your line