how is fishing in buffalo

[Workinman]

Went out Monday out of Dunkirk to do a little Perch fishing, while looking around for the perch I saw what looked to be a lot of walleye laying tight to the bottom just out passed the firsrt drop off about 32 fow. i will be trolling that area this week end, just hope they aren't farm animals.

[copo427ss]

Went out Monday out of Dunkirk to do a little Perch fishing, while looking around for the perch I saw what looked to be a lot of walleye laying tight to the bottom just out passed the firsrt drop off about 32 fow. i will be trolling that area this week end, just hope they aren't farm animals.

Also try bottom bouncing. At a slow troll or drift.

[Workinman]

Your right, thanks I have to back it down we went down to Port Clinton Ohio and I got into trolling mode...can't wait!

[smikac32]

Anybody know any local stores that sell trolling plate or is anyone have a used one up for sale? I have a 50 horse johnson and cant get it to slow down enough. Again thanks for all your help

[milt]

c-me marine on hertel has them web site is c-measles.com phone no 837-5232 hrs are mon tues thurs fri 11-8 sat 10-4 closed on wed and sun I got the happy troller $109.99 I got my verado 150 down to 1.2-1.4 mph (gps) its aluminum

[bailey]

Smika try moving pin for tilt up or down or adjust trim up if power a little change in prop levelness goes a long way. On lake o i have a setting that gives me 2.5 at idol and raise it a little and i get 1.5 . Give it a whirl might work just make sure pick ups for water stay plenty submerged.

[joes spot]

about time the weather setteld down -picked up 10 last nite . bite picked up later in the nite fished 930 to 1 fish were 20/22 and solid / bugs were bad smikac 32 sent you pm on trolling plate

[Chuckup]

before you mount it cut a second notch so the plate does a 45 degree angle. all are designed to do 90 degrees. I did this with my 50 hp Merc and that 45 degree works better than the 90. Its easlier to do it before mounting.

[Fishon51]

before you mount it cut a second notch so the plate does a 45 degree angle. all are designed to do 90 degrees. I did this with my 50 hp Merc and that 45 degree works better than the 90. Its easlier to do it before mounting.

I did the same and it does work better.

[captainjoe]

The good guys won today 12-2. We beat the undefeated team. We ten run ruled them in six innings. They cloubered us the first time we played them. The quest continues.

I'm in for career change. I haven't decided what I want to be when I grow up.