Purchased a new striper 2601 (made by Larson) in 2014. After about a year and a half I noticed many area of the coating on the inside of the boat around the engine compartment are flaking off. Lots of cracks around where anything is screwed into the hull. Very unsightly and probably a safety concern as some of this material will no doubt end up in my bilge pumps. Larson warranty department not real helpful.... Downplaying the problem. Only wanting to do spot repairs. Basically anywhere you can get a look at the bilge area even in the bow of the boat it is pealing off.... Pretty disgusted!

Any thoughts who I could take this to to have it analyzed or repaired. Larson says they will pay but they rejected my local boat repair shops opinions and work scope...

Sorry to post this in the fishing report section but I know this area gets a lot of views and there are a number of knowledgeable people that post here....

Thanks

Jason