Thanks: 0
Likes: 0
Results 1 to 6 of 6
Hybrid View
-
09-30-2017, 03:52 PM #1
Hopefully the picture I tried to attach shows up, it shows the new location for the tow arm. Also if you are running hard pulling divers you can dremel out the partition in front of the ballast weight and then slide the weight forward. Just drill an additional hole in the board to accommodate the screw in the forward position. The picture shows the weight in the forward position.
Last edited by Gradyfish; 09-30-2017 at 03:54 PM. Reason: Forgot something
-
09-30-2017, 10:52 PM #2
Our tow point is about the same.....I also opened up the weight slot, but did not need to move it forward. That little price of plastic was a lot harder to remove than I first thought it would be.
I pull bandits in the spring......was able to run then just as the boards came, but behind the 40 tt you could pull whatever you wanted, spoons, harness, flickers, bombers, p10s, j7/9.
Similar Threads
-
Dipsy vs jets
By Fishhawk97 in forum Western Lake Erie Fishing REPORTSReplies: 11Last Post: 10-11-2017, 11:33 AM -
Go to cranks?
By pollock-a-lope in forum Western Lake Erie Fishing REPORTSReplies: 9Last Post: 03-20-2016, 07:08 AM -
Walleye are back! Time to pull the boat...
By Madd Matt in forum Western Lake Erie Fishing REPORTSReplies: 3Last Post: 10-14-2015, 10:43 PM -
Would you pull a boat trailer with a flat tire?
By WillCFish in forum Boats & MotorsReplies: 4Last Post: 09-11-2013, 08:46 PM -
Trolling cranks
By kodiak50 in forum Western Lake Erie Fishing DiscussionReplies: 3Last Post: 05-24-2012, 10:44 AM
We did well yesterday a couple...
Kelley's