![Thanks](https://community.walleye.com/dbtech/thanks/images/thanks.png)
![Likes](https://community.walleye.com/dbtech/thanks/images/likes.png)
Results 1 to 10 of 12
Thread: Fuel pump to carb line
Hybrid View
-
06-30-2016, 02:22 PM #1
As long as it is carbureted the fuel pressure will be very low, less than 10 PSI. Injected it could be higher than 50 PSI.
You can get by with using reinforced neoprene fuel line that can be purchased at an automotive supply store. I have seen more hoses damaged by screw type hose clamps than you can shake a stick at. Usually because someone over tightened them. Zip ties will work but over time heat and sun light can degrade them and you do not want a fuel leak.. I would use spring clamps that fit the hose. Make sure that the hose stay clear of actuators, pivot points, and cables. Do not strap the hose to any high temperature surface.
This should be a good permanent repair .
PimplePounderLast edited by pimplepounder; 06-30-2016 at 02:23 PM. Reason: mis-spelling
PimplePounder
Ranger Cherokee 237 18ft.
115 HP. Johnson SPL
15 HP Merc. Kicker
Xi5 Motorguide Auto Anchor/GPS
FL-20 Vexilar
898 HD DI SI Humminbird GPS
Navonics Premium
Similar Threads
-
Gas dock fuel prices
By Chuck E. in forum Western Lake Erie Fishing REPORTSReplies: 6Last Post: 07-07-2018, 02:41 PM -
Fuel anywhere yet?
By JBD's Regina Marie in forum Western Lake Erie Fishing REPORTSReplies: 1Last Post: 03-20-2018, 03:53 PM -
Kicker motor fuel hook up
By Crfmatt in forum The Walleye MARKETPLACEReplies: 1Last Post: 10-26-2014, 05:53 PM -
Water in fuel
By Fish on7787 in forum The Walleye MARKETPLACEReplies: 0Last Post: 07-21-2013, 08:32 AM -
fuel price
By empty hooks in forum Western Lake Erie Fishing REPORTSReplies: 6Last Post: 05-24-2012, 11:31 PM
Nicely done and great report as...
Fishing with Gary, Denny, and...