I also thank you for the information. I did notice that for some reason the lat/lon
when you move the mouse around does not seem to be correct.
Kevin
END MEDIAVINE MIGRATION 2026-07-01 -->
I also thank you for the information. I did notice that for some reason the lat/lon
when you move the mouse around does not seem to be correct.
Kevin
You are all welcome and a big THANKS to the 3 guys that towed my sorry butt off the lake Sunday. The wife and I had ran out way past C can and culled a ticket of over 9 inchers in a hour and a half. We caught around a 100 by 10 am along with a lot of trash. It was nonstop the whole time. 31.5 FOW and straight line 2 hooks, no spreader or bling. On the way back in my shift linkage became unhooked in the lower end. We were stuck in reverse. After plugging along for close to an hour we putted through the pack at C can (backwards) and thankfully 3 older guys noticed our dilemma and offered a tow back to turtle. I have the boat ready to go as of now. Hopefully we can make another trip Sat. or Sun.
Welcome aboard Ack, great looking site.
Gene
Very nice! Thanks for sharing.
Thanks for the map and welcome to the forum.
"ReelTime"
Kencraft Challenger 215
Ditto on the Ap, thanks for sharing!!! Now i just need a bigger phone to see it better.....![]()
I don't think there's anything wrong with the lat/lon values that this system provides. For example, if you hover your mouse pointer over West Sister Island, the values should be something in the neighborhood of "lat 41.738867 lon -83.096843." You can convert these values to minutes and seconds by doing the math:
41 = 41 degrees
.73 * 60 = 43.8 minutes
.0088 * 3600 = 31.68 seconds
41 43.8' 31.8" is almost spot on according to my sources. Thanks for sharing this map..