Thanks: 0
Likes: 0
Results 1,671 to 1,680 of 4646
Thread: how is fishing in buffalo
-
06-18-2013, 07:44 AM #1671
-
06-18-2013, 08:01 AM #1672
Capt. Joe, just kidding hope the upgrade works for you. I love my elite 7 now that I got one that works (so far). Congrats on all the wins.
-
06-18-2013, 09:02 AM #1673
picked up 6 last nite one 31 in we put back/ moss is starting to come around
-
06-18-2013, 01:19 PM #1674
Is anyone going out tonight?
I'm heading out after work.
I might not make it to the lake if the waves are too high.
If that's the case, ill hang out in the south gap and go for some bass.
-
06-18-2013, 02:42 PM #1675
capt joe if you go with the gen2 get it with lake insight it has contour lines shows the docks in the harbors underwater pipes and everything else fishing hot spot card has and more good luck
-
06-18-2013, 08:31 PM #1676
Well my HDS5 is on it's way to San Diego, I understand that it should be there on Thursday, Milt I do have the Navionics Gold chip to use in the new unit when I get it. I bought it last year and used it in the HDS5.
-
06-18-2013, 08:35 PM #1677
Fished this morning with my son. Limited out at 11:30 AM. Caught, measured and weighed a 30" 10 pounder. Had a bad lamprey mark on the side. Handled it gently. Took a few pics and put it back in the lake. Fished Meyers Reef. Water was a bit off color. The fish were on top of the reef all morning. Bottom bouncers and worm harnesses.
Dennis
-
06-19-2013, 07:09 AM #1678
Wrong Style Of Fishing
I went out last night, and only got 2 small sheep head.
Would anyone be willing to take me out and give me a lesson or two?
I'm using bottom bouncers with harnesses, and dipsys with harnesses and spoons.
Have stick baits been producing?
I have yet to try these.
My harnesses never seem to stay on the bottom regardless of speed or weight.
My dipsys only go straight, neither of them pull to the side.
I'm also having a difficult time tuning the tension on the release of the dipsy.
Its either too hard and wont release, of too soft, and pops prematurely.
I would really like a lesson if someone has the time.
I'm slipped at the NFTA if anyone is there also?
Thanks
-
06-19-2013, 09:07 AM #1679
For me not many fish came off stick bates. The dipsy can be tricky. Set the tension screw to the pressure you want to release it. Sometimes it's molded to tight and you nay have to file or adjust it. The bottom of the dipsy has a adjustment for left or right.you want to make sure it's in the right side of the boat and tightened. Sometimes the current will pull it. It may appear that it's going behind but UT's off to the side.
-
06-19-2013, 10:08 AM #1680
I know about the L or R adjustment, I have those correct, just doesn't look like its operating correctly.
I might try to file the release gap a little, this might work.
I'm using a #0, is that too small?
I'm using it at the "3" setting for L & R, and according to the chart, for 35 FOW with the O-ring, 220' of line out is needed at 2.5 knots. (2.9mph)
I'm trolling slower than that, roughly about 0.8-2.0 mph, so I'm assuming 200'-210' of line out?
Should I get a #1?
I think #3 is way too big, am I correct?
Thanks
-
Similar Threads
-
2018 Buffalo area fishing reports..........
By Mr. Roboto in forum Eastern Lake Erie Fishing REPORTSReplies: 158Last Post: 04-21-2019, 09:40 AM -
Currently off Buffalo
By NateD in forum Eastern Lake Erie Fishing REPORTSReplies: 0Last Post: 07-15-2017, 03:55 PM -
Fishing from Buffalo NY
By daker1979 in forum Eastern Lake Erie Fishing REPORTSReplies: 5Last Post: 06-03-2015, 06:05 PM -
buffalo police
By jerky in forum Eastern Lake Erie Fishing REPORTSReplies: 40Last Post: 07-14-2014, 11:15 PM -
Buffalo boat lauches-walleye fishing
By Bababouy in forum Eastern Lake Erie Fishing REPORTSReplies: 2Last Post: 05-31-2008, 07:10 AM
Thanks for the sound advice for...
Styrofoam minnow bucket lid...