Thanks: 0
Likes: 0
Results 1 to 6 of 6
Threaded View
-
09-30-2017, 03:52 PM #5
Hopefully the picture I tried to attach shows up, it shows the new location for the tow arm. Also if you are running hard pulling divers you can dremel out the partition in front of the ballast weight and then slide the weight forward. Just drill an additional hole in the board to accommodate the screw in the forward position. The picture shows the weight in the forward position.
Last edited by Gradyfish; 09-30-2017 at 03:54 PM. Reason: Forgot something
Similar Threads
-
Dipsy vs jets
By Fishhawk97 in forum Western Lake Erie Fishing REPORTSReplies: 11Last Post: 10-11-2017, 11:33 AM -
Go to cranks?
By pollock-a-lope in forum Western Lake Erie Fishing REPORTSReplies: 9Last Post: 03-20-2016, 07:08 AM -
Walleye are back! Time to pull the boat...
By Madd Matt in forum Western Lake Erie Fishing REPORTSReplies: 3Last Post: 10-14-2015, 10:43 PM -
Would you pull a boat trailer with a flat tire?
By WillCFish in forum Boats & MotorsReplies: 4Last Post: 09-11-2013, 08:46 PM -
Trolling cranks
By kodiak50 in forum Western Lake Erie Fishing DiscussionReplies: 3Last Post: 05-24-2012, 10:44 AM
Thanks for sharing, I hope to get...
Draggin the Line with John