Thanks: 0
Likes: 0
Results 1 to 4 of 4
Thread: using tattle flags and divers
-
07-24-2013, 12:24 AM #1
using tattle flags and divers
When using the tattle flags on in-line boards will the tru tip and jet divers pull to hard to make the flags work or should I just stick with snap weights ?
-
07-24-2013, 04:15 AM #2
I made my own tattle flags and jet releases, these both work perfect for me. If your using a spring on your inline board, you could add a rubber band, I just use a single rubber band on each board and I can set it tight enough so nothing pulls the flag down if I want.
I can only hope I have earned the freedom that has been given me.
-
07-24-2013, 10:22 AM #3
Thanks ebijack... good idea there , I'll give it a try
-
07-24-2013, 10:26 AM #4
boards
I drilled a series of holes vertically along the edge of my boards, using a spring, I just move the spring up or down holes to compensate for the tension needed, works good too ! Mike
-
Similar Threads
-
Dipsy divers?
By Bob in forum Western Lake Erie Fishing REPORTSReplies: 8Last Post: 04-29-2016, 08:23 AM -
Trolling jet divers
By Domers98 in forum Western Lake Erie Fishing DiscussionReplies: 3Last Post: 09-04-2013, 07:44 AM -
Offshore Planer Boards with Tattle Flags – One Port & One Starboard
By Capt Kent in forum The Walleye MARKETPLACEReplies: 1Last Post: 03-15-2012, 07:09 PM -
Jet Divers!!!!!
By nippissinger in forum Eastern Lake Erie Fishing REPORTSReplies: 6Last Post: 08-01-2011, 05:51 PM -
jet divers
By jm gremore in forum Western Lake Erie Fishing REPORTSReplies: 4Last Post: 05-07-2008, 04:02 PM
Thanks for the sound advice for...
Styrofoam minnow bucket lid...