Rigging big board tow planer boards

Hey fellas, finally figured out the joy of planer boards and running bandits, been using inline offshore boards picked up a couple drag planer boards. Need to mount a post on the side of my boat to use them though. Anybody have any ideas on how to rig these. Thanks for all the help guys. Was out there by the reefs till about 11 30 yesterday and decided to get the hell out of there while the getting was good. Picked up 7 yesterday, 4 keepers. All hit on gold with black bandit. 60 feet back, tight lines sailers

Hey Rider. I fabricated a 2x6 board that mounts across the bow of my boat. It has two vertical posts to run the boards off. I let them out and reel them in by hand. Drilled holes and used J Hooks to hook underneath of the cleats. Washers and wing nuts on top. Depends on your boat layout really.

Like the previous poster said, it really depends on the type of boat you are running, your budget and other variables. I have a set of big boards with a mast, and in-line planers. I I have a 20 foot Lund.

Since I didn't think I would use the big boards all that often, I didn't want to spend a ton of money on them, so I went the DIY route. I made my own boards, mast, etc. I have my mast in the very front of my boat, mounted to the board that my Trolling Motor mounts to in a Traxtech track. The mast is a 6 foot oak dowel-rod 1.5" in diameter. It slides into a Trax-Tech Heavy Duty Net Holder. I put pipe-insulating foam around it to make it fit snugly.

It has bolt-eyes at the top on each side that the planer board line runs through and I mounted two older trolling reels to the bottom of it with hose clamps (one on each side). I have 150 feet of that orange planer board line on each reel and I just let it all out and reel it all back in when I am done, but I could let it out part-way if I wanted to.

For releases, I just bought a large bag of shower curtain rings and several bags of rubber bands. Half-hitch a rubber band around the line, put it in the shower curtain ring and it slides down the line. When a fish hits, the rubber band breaks and you reel in the fish. The nice part is, when the line releases, you don't have to fight the board on the way in. The used release slides down to the next one (or to the board) if it was the outside line. You just leave them out there until you bring in the boards. So you need lots of releases. When you put it back out, that line becomes the inside line and the rest slide over one spot.

This all works great with large fish. Where it gets a bit dicey is with smaller fish or junk fish, as they tend to just stretch the rubber band and can't snap it. I normally use my big boards for steelhead, so that usually wasn't an issue. If I used them more for walleyes, I would probably get a bunch of those yellow releases that are made for planer boards, or come up with another plan.

I tend to make short passes, mostly downwind, and I am usually only running 4 or 6 lines, so I have found that in-lines work better for me. I am constantly bringing them in to make another pass, which is a pain with the big boards, so I don't use my big boards all that often.